
WHY IT MATTERS
Beam quality matters more than lumen count
Beam quality
Low light loss
True lumens
A well-shaped beam puts light where it is needed: an even spread with no dark spots or harsh rings, and the right balance of spot and flood for the task.
Our published figures follow the ANSI/NEMA FL1 standard: light output is measured 30 seconds after switch-on, not as a peak at the moment the light comes on.
Every lens and reflector loses some light. We design our optics to keep that loss low, so more of the LED’s output reaches the road or the trail.
SEE THE DIFFERENCE
Anti-glare cut-off beam vs a normal spot beam


No glare
Wider vision
Better ground visibility

Cut-off beam on a wall: wide, with a flat top edge
On all RZ bike headlights and the MAKT300, 500 and 800, the beam has a flat top edge, so light stays out of the eyes of oncoming riders, walkers and drivers, while keeping the high lumen output.
More of the light lands on the road ahead, where the rider needs to see.
The beam spreads wider horizontally, for a wider field of vision.

Normal spot beam on a wall: a round hotspot
OPTICS IN OUR RANGE
The right beam for each job
Semi-cutoff beam
Double beam
Quick zoom
Spot and wide vision
Wide-angle rear lights
All RZ bike headlights and the MAKT300, 500 and 800: a lens gives the beam a flat upper edge, like a car’s dipped headlight. Light lands on the road ahead, so oncoming riders and drivers are not dazzled.
RZ DB 2500 (BA609) has two beams in one light: an anti-glare semi-cutoff beam for the road ahead, and a focused beam for longer distance.
Eclipse and Fastro headlamps: a 45° turn of the lens ring takes the beam from wide flood to narrow spot.
Proton bike lights: ultra-slim optics combine a spot with a wide-vision spread, for a wide visibility range.
Tail light optics spread the light wide, so the rider is seen from the side as well as from behind.
HOW WE DEVELOP AND TEST
Measured on every new design
Designed in-house
Light output and beam
Published data
A beam to your brief
Optics are designed together with the housing and electronics, and made on tooling privately owned by Organix Concept.
Light output and beam pattern are measured against spec on every new design.
Light output, runtime and beam distance are given on our spec sheets, measured to ANSI/NEMA FL1.
For ODM projects, we can develop a new version to your brief, including a different output, battery or beam.